Hello again!
I've been working plenty on the cosplay, getting some nerves about not finishing in time for facts.
I just hope it'll be done.
One thing at a time, so I decided to finish the shoulder armor for Hiccup.
I already cut out the biggest piece, shaped it and panted it black.
I needed the round shape, so I just took the big piece and outlined it on a piece of paper.
Then I just made it smaller and outlined that shape on to foam.
on the side there's a little belt as you can see on the third picture.
standard cutting out, paint it and glueing it on the shape. Unfortunately I wasn't really paying attention and already glued it before I glued the smaller circle.
I took some 2mm foam for the shape inside.
Again pretty easy to do;
Find a good picture of it, draw it the right size (I placed a piece of paper underneath the inner circle to make sure the size was right) and then cut it out.
Then plastic-dip it and paint.
Here you can see all the shapes before glueing everything.
I then took a pen and drew where they should go onto the big shape.
This way my contact glue isn't spread all over and stays nicely between the lines.
shape drawn onto the foam.
This is a picture of the full shoulder armor.
The pieces arn't attached yet, but it's to give me an idea of what it will look like.
As you can see I already painted the shapes that go under the black armor.
Yes I'm crazy for sewing the whole thing since you can't see it. But I'll know it's not done and that will bug me.. BIG TIME.
The light grey lines you can see on the biggest shoulder armor are yet to be painted and everything needs some roughing up. but I'm really glad that they are (nearly) finished.
STOÏC
So the amulets on Stoïc's cosplay are up next!
First I printed the shapes out. I took the shapes from screenshots of the actual movie. Not easy!
Then I made sure that the pieces are the right size.
To place the drawing on to the foam I just use a oily pencil make the back black and then simply outline it.
I don't have pictures of me using the dremel for cutting out the shapes.
This I can say:
It takes a lot of time to find the right tool for these lines. It all depends on what you like to use.
Try some different tools until the right one.
Once I cut the shapes out with the dremel I simply used some plasti-dip and then quickly stamped the wet paint onto a new piece of foam.
that way I don't have to draw it again.
!!!Use full tip everybody!!!
Next is putting on the silver paint.
I used a cloth for this. Just rub it on until you get the wanted result. If it's to shiny, then get some black paint and keep on going until it looks like YOU want it to look.
On to the belt amulet!
This was so much work!
I really underestimated it!
Again looking for the right tool to put in the dremel was hard, but I eventually found the right one.
The same technique was used like the other amulets.
That's it...
The amulets took me a whole day to make.
Over and out for today!






















Comments
Post a Comment