Hiccups armor... and aaaallllll the details

Soooo here we go! 

I've made the armor this weekend and this came with trial and error.

Just keep adjusting the templates until you are sure you have the right size and shape, 
looking at the pictures a trillion times ;-)




This is what it should look like:


The shoulders and belt are yet to come. 
But first lets do the center piece shall we? 


You know the drill! 
Once you have the template, put it on the foam, draw it over and cut it out. 

Then assemble everything together like so:



I've used my handy tool again to make the edges appear like they were stitched before glueing it all together.  


Also I made 2 (straight) pieces to use as a collar. Just glue them on. 
If you have trouble with the shape then you can always use a heatgun to bend it into place first. 




You can't see properly, but on the edges there's a stretcher. I did this for the practicality
since you almost can't see the side. 




After this I needed some fun things to do!

So I started with making some details. 

Well, ok, this first thing is not as much fun as I thought. 
Shaping some little and bigger balls with foam clay so I can cut them in half later to make the buttons. 



What's next you ask? 
Welllllll


This is.... The compass. 

Then I cut out a strip of the 5mm foam and made edges on the 2 sides by cutting it. 


Then I went rogue and just tried something. 
I cut out the middle. 


As you can see this is not a smooth result. 


But have no fear because my dremel is here! 


After that was done I started with the top of the compass. 
I used the 8mm foam and just cut out the shape. 



I then smoothed everything out with my dremel again. 


Then drew on the lines and started mill out the shapes. 


Some layers of plasti dip...


And a first layer of metallic paint... 



This is not the end result off course. 
It still needs A LOT of finishing before it is done. 

Last, but not least. 
The emblem on the belt of the armor. 

This.

This was actually pretty easy. 
I took the picture above. Drew it over with some chalk paper,
And then used said paper to draw it on the foam. 


I used the 2 mm foam for this. 


 And made a lower part out of the same foam. 
This will be put together once the dragon is painted in red. 


Ready for some plasti dip! 


Wanna know more about the materials I use? 
please check out this website for all your products! 

Steve will help you with any questions you may have, 
or you can come down to the shop and talk to other cosplayers who are eager to share their experience and expertise. 





Comments